L461 Fixed Side Steps

Product Overview

The L461 Fixed Side Steps kit (VPLXFSS01CoBl) delivers genuine OEM static running‑board hardware for Range Rover Sport L461 DOIP‑chassis vehicles across 2023‑2027, and it supports NAS, EU, CN and RoW global markets. Furthermore, this non‑motorised side‑step set improves cabin entry‑exit ergonomics, and it also creates a stable platform to reach roof‑mounted accessories. However, you must understand that fitment reduces factory ground clearance; consequently, it lowers the vehicle’s standard off‑road capability. Unlike generic aftermarket side‑steps, JLR validates this full kit for load‑rating, corrosion resistance and chassis‑mount stress testing. Since this is a fully mechanical exterior accessory, you will not perform any DOIP control‑module configuration, and no DTC fault‑codes will appear after you finish installation. Importantly, independent body‑shops, accessory retrofit specialists and competent DIY technicians should follow TOPIX fitting reference G3316394 for every fitment step.

JLR Technical Specifications & Core Features

• Static Non‑Deployable Design: Left‑hand and right‑hand fixed assemblies; they sit permanently in position below vehicle sills with no moving motor‑driven components.
• Brushed Metal + Rubber Tread Surface: Hard‑wearing rubber tread pads carry laser‑etched Range‑Rover branding, and they deliver slip‑resistant grip in wet or icy conditions.
• Chassis‑Specific Mount Geometry: Purpose‑engineered brackets bolt straight to factory chassis mounting locations; you avoid destructive drilling to vehicle body panels.
• Certified Static Load Rating: Each side‑step supports up to 150 kg static user‑weight; do NOT use assemblies as jacking lifting‑points.
• Climate‑Resistant Construction: Surface finishes resist road‑salt corrosion, UV fading and winter‑temperature cycling for worldwide market operation.
• Reversible Fitment: You can fully remove all assemblies and restore original factory sill appearance without permanent chassis damage.

Vehicle Prerequisites & Technical Constraints (JLR Workshop Standard)

Before you start any work, review TOPIX procedure G3316394 carefully. Additionally, confirm your vehicle holds factory chassis mounting bosses; some high‑performance SV variants do not accept this fixed‑side‑step hardware. Run our JLR‑Decoder VIN‑decode before you place your order, because this check confirms your trim‑variant build‑option status. While you perform installation, torque all bracket fasteners strictly to JLR specified torque values; over‑torque will deform chassis mounting points. After you complete fitment, inspect full suspension compression and full‑lock steering travel, so you confirm zero tyre‑to‑step interference. Since ground‑clearance decreases after fitment, adjust your off‑road driving style accordingly. You run zero diagnostic tool procedures for this kit; you will not open Pathfinder or CCF‑Tools at any stage.

Kit Contents

• Genuine left‑hand fixed side‑step assembly (VPLXFSS01CoBl)
• Genuine right‑hand fixed side‑step assembly (VPLXFSS01CoBl)
• L461‑specific left‑hand and right‑hand heavy‑duty mounting‑bracket set
• Full OEM fastener pack including torque‑spec bolts, anti‑corrosion washers and sill closure trim strips
• Protective transit foam sleeves for each running‑board unit
• Printed fitting‑instructions referencing TOPIX procedure G3316394

Ordering Information

Once you finish purchase, you receive reference excerpts from our TEC‑DOC library with TOPIX fitment guidance. This listing supplies physical OEM hardware only; diagnostic tools do not form part of this sale. Submit your 17‑digit VIN during checkout, and our team completes pre‑sales variant‑compatibility screening. Finally, we issue a full‑order refund whenever your vehicle variant proves incompatible with this fixed side‑step kit.