L461 Mudflaps – Front

Product Overview

The L461 Mudflaps – Front kit (VPLXP0527) is genuine OEM exterior‑protection accessory built for standard‑bumper Range Rover Sport L461 DOIP‑chassis vehicles covering 2023‑2027 model‑years across NAS, EU, CN and RoW global markets. Manufactured from impact‑resistant flexible TPO polymer, this left‑right splash‑guard pair is tooled precisely to match L461 front‑bumper and front wheel‑arch geometry. Its primary function is to deflect road‑debris, stones, mud and tyre‑spray away from front‑fender paint surfaces, lower‑door panels and brake cooling components. Unlike generic aftermarket mud flaps, this JLR accessory completes factory validation for cold‑flex cracking, UV‑fade and road‑salt exposure. This is a purely mechanical‑fit accessory; no DOIP‑control‑module configuration is needed and no DTC fault‑codes will log post‑installation. Suitable for independent body‑shops, over‑land retrofit specialists and competent DIY technicians following TOPIX fitting document G3181882.

JLR Technical Specifications & Core Features

• Vehicle‑Specific Contoured Geometry: Matched left‑right pair engineered exclusively for L461 standard front‑bumper; not for Dynamic / SV bumper derivatives.
• High‑Grade TPO‑Polymer Material: Flexible impact‑resistant compound, resistant to sub‑zero cold‑cracking, UV‑stabilised against sun‑fade and road‑salt corrosion.
• OEM‑Matching Matte‑Black Finish: Surface finish harmonises with factory lower‑body cladding and bumper trim aesthetic.
• Factory‑Point Mounting System: Utilises pre‑existing wheel‑arch liner and bumper mounting holes; destructive drilling into body panels is prohibited per TOPIX instructions.
• Optimised Deflector Profile: Tuned flap height and angle to minimise stone‑chip impact on front‑fenders while preserving full steering‑suspension travel clearance.
• Reversible Fitment: Full removal without permanent damage to bumper or wheel‑arch liners, restoring stock exterior appearance.

Installation & Compatibility Notes (JLR TOPIX Workshop Standard)

Fitment must strictly follow TOPIX accessory fitting document reference G3181882 and exterior‑trim workshop section 501‑08. This VPLXP0527 kit is for standard S / SE front‑bumper variants only; incompatible with Dynamic‑SE, Autobiography and SV‑spec front bumper assemblies (VPLXP0528 is the separate Dynamic‑bumper variant kit). Installation requires partial wheel‑arch liner removal; technicians must exercise care to avoid snapping plastic retention clips. No CCF‑Tools or Pathfinder service‑routine execution is required. Post‑fitment perform full lock‑to‑lock steering check and suspension compression inspection to verify zero contact‑rubbing between mudflaps and tyre / suspension components. Always complete JLR‑Decoder VIN‑decode to inspect your vehicle’s front‑bumper build‑option code prior to ordering.

Kit Contents

• Genuine left‑hand front mudflap (VPLXP0527)
• Genuine right‑hand front mudflap (VPLXP0527)
• Complete OEM mounting brackets, push‑clips, screws and spacer hardware set
• Protective transit foam sleeves for each mud‑flap unit
• Printed fitting‑instructions referencing TOPIX document G3181882

Ordering Information

Upon purchase you receive reference excerpts from our TEC‑DOC library for TOPIX G3181882 fitment guidance. This listing supplies physical OEM hardware for professional‑workshop or competent‑DIY installation. Submit your 17‑digit VIN at checkout for pre‑sales front‑bumper‑variant compatibility screening. Full‑order refund applies if your vehicle bumper configuration is incompatible with VPLXP0527 standard‑bumper front mudflap kit.