L461 Mudflaps – Rear

Product Overview

The L461 Mudflaps – Rear kit (VPLXP0529) is genuine OEM exterior‑protection accessory for Range Rover Sport L461 DOIP‑chassis vehicles covering 2023‑2027 model‑years across NAS, EU, CN and RoW global markets. Manufactured from durable flexible TPO polymer, these rear splash‑guards are tooled precisely to follow the L461 rear‑bumper and wheel‑arch geometry. Their primary function is to mitigate stone‑chipping, road‑grime accumulation and water spray onto rear body panels, rear‑door paintwork and tow‑hitch hardware. Unlike universal aftermarket mud flaps, this JLR accessory undergoes vibration, cold‑flex and UV‑ageing validation for year‑round use in harsh winter‑salt and off‑road environments. This is a purely mechanical‑fit accessory; no DOIP‑control‑module configuration is needed and no DTC fault‑codes will log post‑installation. Suitable for independent body‑shops, off‑road retrofit specialists and competent DIY technicians following TOPIX exterior‑trim fitting documentation.

JLR Technical Specifications & Core Features

• Vehicle‑Specific Contoured Geometry: Left‑right matched pair shaped exclusively for L461 factory rear‑bumper and wheel‑arch profile; no trimming required for correct fitment.
• High‑Performance TPO‑Polymer Construction: Flexible impact‑resistant material, resistant to cold‑cracking in sub‑zero temperatures, UV‑stabilised against sun‑fade and road‑salt corrosion.
• OEM‑Matching Matte‑Black Finish: Co‑extruded surface finish harmonising with factory lower‑body cladding and bumper trim aesthetic.
• Direct‑Mount Fastening System: Uses existing factory bumper and wheel‑arch liner mounting points; no destructive drilling into vehicle body panels permitted per TOPIX instructions.
• Functional Spray‑Reduction Design: Optimised flap height and profile to deflect stones, mud and tyre‑spray away from rear body, lamp assemblies and tow‑bar fitments.
• Reversible Fitment: Can be fully removed without permanent damage to bumper or inner wheel‑arch liners, restoring stock vehicle appearance.

Installation & Compatibility Notes (JLR TOPIX Workshop Standard)

Fitment must follow JLR TOPIX exterior‑trim fitting procedure reference section 501‑08. This rear mudflap kit has bumper‑variant dependency; it is not compatible with certain high‑performance rear‑bumper / SV body kits. Fitment utilises pre‑existing mounting holes within rear bumper and wheel‑arch inner liner. Operators must take care during liner removal to avoid snapping plastic retention clips. No CCF‑Tools or Pathfinder service‑routine execution is required. After installation perform visual inspection: confirm adequate tyre‑clearance through full suspension compression and steering‑travel range to eliminate rubbing risk. Always run JLR‑Decoder VIN‑decode to inspect your vehicle’s rear‑bumper build‑option code prior to ordering.

Kit Contents

• Genuine left‑hand rear mudflap (VPLXP0529)
• Genuine right‑hand rear mudflap (VPLXP0529)
• Complete OEM replacement push‑clips, screws and spacer mounting hardware set
• Protective transit foam sleeves for each mud‑flap unit
• Printed fitting‑instructions referencing TOPIX exterior‑trim section 501‑08

Ordering Information

Upon purchase you receive reference excerpts from our TEC‑DOC library for TOPIX exterior‑trim fitment guidance. This listing supplies physical OEM hardware for professional‑workshop or competent‑DIY installation. Submit your 17‑digit VIN at checkout for pre‑sales rear‑bumper‑variant compatibility screening. Full‑order refund applies if your vehicle’s bumper configuration is incompatible with this mud‑flap kit.